To wire brush and power vacuum clean fireside portion of boiler free of all loose soot and debris.
To remove all handhole and manhole assemblies from waterside portion of boiler.
To flush and wash waterside portion of boiler free of all loose rust and scale.
To dismantle and flush low water cut off assemblies.
To perform inspection of pressure vessel, refractory, and piping.
To close and seal fireside and waterside portion of boiler.
To fill and leak test boiler.
To clean, oil, and adjust burners for maximum combustion efficiency.
To perform electronic combustion efficiency testing.

(The following may not be applicable at all locations):

To inspect and adjust pulleys and v-belts.
To check air leakage: front door and rear door.
To remove and clean: Fuel oil cleaner, oil nozzle assembly, and gas pilot assembly.

To cycle burner and check pilot operation, main flame ignition, and combustion controls.
To check for leakage: Oil pump, oil strainer, oil piping, and oil valves.
To check operation: Linkages, and modulator.
To inspect and test: Thermal safety, low gas pressure switch, high gas pressure switch, air pressure switch, L.W.C.O., fan control, aquastat/pressuretrol, condensate pumps, flame safe controls.

Manhattan Welding Company, Inc. will coordinate annual State Insurance Inspections at the customer's request and at no extra charge.

CALL 1-800-834-WELD